Humidity & Temperature Monitoring Sensor Probe

Temperature & Humidity Sensor Probe for the SensorGateway

Requires the SensorGateway


  
Not only temperature affects systems performance but also humidity can cause rapid deterioration of systems. Monitoring humidity in a data center is as important as monitoring temperature! Too low humidity may result in ESD causing immediate permant equipment damage. Too high humidity could create corrosion on components, a slow and often irrevirsible process.

ServersCheck offers a low cost PoE & SNMP ethernet based sensor for monitoring not only humidity but also temperature 24x7. This sensor measures the relative humidity (0 and 100 % RH) and temperature (-40 C and +75 C, -40 F to +167 F) with improved resolution. This sensor is designed to monitor conditions in server rooms and other sensitive area's. You get 2 temperature sensors: one, non-calibrated, built-in into the SensorGateway and one inside the external probe. Humidity reading is done through the external probe.

The probe connects via the shipped RJ45 cable to the SensorGateway on the Probe 1 or Probe 2 port. It can alert you autonomously through email or SNMP Traps. Need SMS alerting? Then this is possible by using the ServersCheck Monitoring Software/Appliance which monitors centrally all different sensors running in your network.



Temperature & Humidity Sensor Probe
Temperature Resolution: 0.1°C (0.18)°F precision
Temperature Accuracy: +/- 0.5ºC (+/- 0.9 ºF) over 0ºC to +60ºC
Readings in Celsius or Fahrenheit
Relative Humidity Measurement Range: 0 to 100 % RH
Relative Humidity Resolution or precision: 0.1 % RH and 1 % RH
Relative Humidity Accuracy: +/- 2 % RH between 10 % RH to 90 % RH and +/- 4 % RH below 10 % RH and above 90 % RH
Relative Humidity Long Term Stability: < 1 % RH/year
Operating temperature range: 0ºC to +75ºC (32ºF to +167ºF) in PoE mode
Operating humidity range: < 90% rH (non-condensating)
Dimensions: 74 mm (2.9") x 66 mm (2.59") x 22 mm (0.8")
Housing: Orange metal case with status led
0U Rack mountable
Connects via included 50cm/1.6ft regular RJ45 cable to SensorGateway (up to 10m/33ft supported between probe and SensorGateway)
The probe requires the SensorGateway to operate


Important notice to customers: if you received a temperature & humidity probe after March 10th, 2012 then make sure to upgrade your SensorGateway to firmware 2.0.6 or higher.